NVent HOFFMAN has developed a new software tool for low voltage switchgear design for electrical engineering companies involved in the manufacturing of low-voltage switchgear. NVent HOFFMAN® as the copyright owner has the exclusive right to make changes and/or adjustments to its software or install patches without prior notification on this website.īy downloading any of these softwares you agree to terms and conditions above. NVent HOFFMAN® assumes no responsibility or liability for any use of the nVent HOFFMAN® software. Please note that the software is supplied "AS IS" and therefore it comes without any warranties and/or support. As no encoder or additional cables are needed, engineering, installation and commissioning time and costs can be reduced.You are welcome to use the nVent HOFFMAN® software.
This means that knowledge of servo technology or programming languages is not required. Drives are adapted to the applications through simple parameterization. It works with all conventional motor technologies, with closed loop or open loop control, and offers sensor less homing with torque detection. IMC is now configurable in the software of the VLT® AutomationDrive FC 302. The Integrated Motion Controller (IMC) is functionality that enables an AC drive to perform high-precision positioning and synchronization operations without the need for additional modules or hardware. But, until now, an additional internal or external module or an encoder on the motor was required.ĭanfoss Drives has developed an innovative alternative to servo control. Many applications do not require the high dynamic performance offered by a servo drive. And, as servo drives do not work with open loop control systems, there is a high failure rate.
However, servo equipment is expensive it is difficult to commission and requires additional cabling. To date, positioning and synchronization operations have been performed using servo drives.
0 kommentar(er)
